Open official notice

Motorcycles (Yamaha Cygnus X XC125SR and others) - Repair

Official notice

18 Nov 2014

Last checked

27 Oct 2026

RecallScope risk estimate:HighCAA Japan

An official CAA Japan notice concerns Motorcycles (Yamaha Cygnus X XC125SR and others) - Repair. Due to defects in the electrical equipment, speedometer, and running gear. ■Defective parts (component names): ① Electrical equipment (turn signal wiring) ② Speedometer (vehicle speed sensor) ③ Running gear (rear wheel). ■Conditions and causes of the structure, equipment, or performance deemed noncompliant with standards: ① The turn signal relay is secured improperly, allowing the wiring connected to it to bend due to vibration while riding. Continued use may cause the wiring to break through repeated bending, causing the turn signals to stop illuminating. ② The vehicle speed sensor mounted on the front wheel axle has an improper design. When the rotor tilts while riding, lubricating grease may be forced out of the inner-diameter sliding section, resulting in insufficient lubrication. This increases sliding resistance as the rotor rotates and places excessive loads on the rotor tabs. With continued use, in the worst case, the rotor tabs may break and the speedometer may stop working. ③ Some rear wheels were improperly finished at the rim during manufacture. As a result, the tire may not seal properly, allowing air to leak between the rim and tire bead. In the worst case, this may impair riding stability and cause the motorcycle to fall over. Published 2014-11-18.

What to do now

(Recall)3467 ■Corrective measures: ① On all vehicles, replace the rubber bracket used to mount the turn signal relay with an improved part. Also install a corrective sub-harness in the wiring and add a clamp to secure the wiring. ② On all vehicles, replace the vehicle speed sensor with an improved part. ③ On all vehicles, replace the rear wheel assembly with an improved part. However, because preparation of the corrective parts will take time, apply an air-leak sealant to the rear tire bead as an interim measure until parts can be supplied, and replace the assembly with an improved part as soon as parts become available.

Recall number

3467

Official notice

2014-11-18

The hazard

Due to defects in the electrical equipment, speedometer, and running gear. ■Defective parts (component names): ① Electrical equipment (turn signal wiring) ② Speedometer (vehicle speed sensor) ③ Running gear (rear wheel). ■Conditions and causes of the structure, equipment, or performance deemed noncompliant with standards: ① The turn signal relay is secured improperly, allowing the wiring connected to it to bend due to vibration while riding. Continued use may cause the wiring to break through repeated bending, causing the turn signals to stop illuminating. ② The vehicle speed sensor mounted on the front wheel axle has an improper design. When the rotor tilts while riding, lubricating grease may be forced out of the inner-diameter sliding section, resulting in insufficient lubrication. This increases sliding resistance as the rotor rotates and places excessive loads on the rotor tabs. With continued use, in the worst case, the rotor tabs may break and the speedometer may stop working. ③ Some rear wheels were improperly finished at the rim during manufacture. As a result, the tire may not seal properly, allowing air to leak between the rim and tire bead. In the worst case, this may impair riding stability and cause the motorcycle to fall over.

How to check if you're affected

Compare the product name and identifiers below with the item you own. Check the official notice for the affected products and next steps.

Recall Numbers

3467

Checked manually this time?

Add your VIN to the app Watchlist to receive alerts for matching official notices.

Turn on automatic VIN checks

Affected products

Product 1

ヤマハ シグナスX XC125SR 他

Hazard

Due to defects in the electrical equipment, speedometer, and running gear. ■Defective parts (component names): ① Electrical equipment (turn signal wiring) ② Speedometer (vehicle speed sensor) ③ Running gear (rear wheel). ■Conditions and causes of the structure, equipment, or performance deemed noncompliant with standards: ① The turn signal relay is secured improperly, allowing the wiring connected to it to bend due to vibration while riding. Continued use may cause the wiring to break through repeated bending, causing the turn signals to stop illuminating. ② The vehicle speed sensor mounted on the front wheel axle has an improper design. When the rotor tilts while riding, lubricating grease may be forced out of the inner-diameter sliding section, resulting in insufficient lubrication. This increases sliding resistance as the rotor rotates and places excessive loads on the rotor tabs. With continued use, in the worst case, the rotor tabs may break and the speedometer may stop working. ③ Some rear wheels were improperly finished at the rim during manufacture. As a result, the tire may not seal properly, allowing air to leak between the rim and tire bead. In the worst case, this may impair riding stability and cause the motorcycle to fall over.

Where it was sold

Retailer information is not currently available in RecallScope. Check the official notice for distribution details.

Location 1

JP · Japan

Affected area 1

JP · Japan

Company & contacts

Brand

Manufacturer

ヤマハ発動機株式会社

Phone

0120-090-819

Brand: Yamaha. Contact: ヤマハ発動機株式会社. Phone 0120-090-819.

Source & status

Source

Tier

official

Category

VEHICLES

Official classification

消費者庁 — 修理

Recall details

Recall number

3467

Event id

CAA-00000011041

Source tier

official

Documents, notices & source

See the official notice and source documents for full details.

View full official notice
Something wrong on this page?

Weekly recall digest

Get next week's recalls before you need them.

One email every Monday — official-source recalls for your country, and nothing else. Unsubscribe from any email.

The digest arrives once a week. For matching recall alerts after notices are processed, get the app.

This recall was published 18 Nov 2014. The next one won't wait for you to search.

RecallScope checks listed publishers for the brands and VINs you follow, and can alert you when a matching notice is processed.

apple-buttongoogle-button